To Do List - Eddies Summer Plan - stage 1 a.k.a. fixing sh*t

i'll try to put this in chronological order, everything i need to do starting hopefully this week..

Front/Engine Bay:
- compression test
- vacuum engine bay
- Remove front bumper cover/ foglights
- airbag sensor remove
- Remove Hood and Strut Bar
- Remove AC Condensor and side tank (trash), remove radiator and coolant tank , remove and rebuild/ replace alternator
- install new Mishimoto TS, paint water elbows
- remove timing chain guide, inspect inside valve cover, pour a drop of sea foam onto pistons..
- remove intake manifold, tb, rest of egr stuff, redo bypass for summer
- remove intake and MAF, clean maf
- gasket match and polish IM, clean IM new AT 65mm tb, file down butterfly bar and plate edge, replace throttle rod
- clean head side, clean fuel rail, paint
- replace pcv valve
- install billet fuel bracket
- new fuel lines with AN6 fittings
- new DC2 fuel filter with AN6 fittings
- replace clutch MC and Slave Cylinder, bleed
- install lines for oil cooler and filter relocation w/heat sink, oil temp sender for guage
- mock up install of MSD 5520 with intake pipe and apexi elbow and heatsheild in place
- install AIP dizzy and msd 5520
- remove PS tank and lines, install new idler puller
- install weapon R tank and new lines
- replace water pump and belt
- cut rust from rad support/crossmember section, weld/bolt on epoxy covered L brackets and paint with epoxy seal
- replace visible freeze plugs
- clean engine bay
- replace rusty wiper motor
- remove and paint cowl and wiper arms
- replace radiator hoses (3) and replace temp sender for water guage
- replace fog light bulbs, re-wire back to switch
- install LED headlighg strip to switch
- clean headlights, chameleon film
- line up quick releases, install Stillen front lip, paint bumper mount oil cooler and license  plate tilt
- install All Alum radiator and alum coolant tank, bleed system
- oil change, trans fluid 75w-90 GL4 change

- -- - ---- then on to suspension and appearance  !!!!